LVM100 Greenhouse Curtain Motor With Guide Wheels
The LVM100 is a 24VDC low voltage motor built to run curtains, blackout systems, and roof vents, including the higher-load demands of dairy barn curtains. It lifts up to 1,750 sq ft on a single bar curtain or 875 sq ft on a double bar curtain (square footage measured length × width).
This listing includes a complete guide wheel assembly. For motor-only applications where you’re supplying your own wheel set or roll bar hardware, see the LVM100 motor only page for the equivalent single-output configuration.
Automate the LVM100 with one of our environmental controllers, or integrate it into an existing control system with one of our interface boxes.
Setup and limit switches
Directional travel limits are set with two adjustment dials on the limit switch housing, one per direction. Each dial moves a cam closer to or farther from its switch — moving a cam away from its switch increases that direction’s travel. [Link to limit switch setting video]
Before wiring to a controller, the motor can be run on a 24V or less portable tool battery to set limits at low speed while standing next to the motor.
Specifications
| Spec | Value |
|---|---|
| Voltage | 24VDC |
| Amperage | 4.2A |
| Wattage | 100W |
| Output Speed | 3 RPM |
| Output Torque | 100 Nm |
| Output Shaft | 0.78″ (20mm) OD |
| Shaft Output Configuration | Single or Double |
| Drive Shaft Compatibility | SCRB / 1.315″ / 1.66″ / 2.375″ |
| Breaker Required | 5A |
| Curtain Capacity | 1,750 sq ft single bar / 875 sq ft double bar |
Wiring: 14 AWG wire for runs under 100′, 12 AWG for runs over 100′. Motor housing must be installed above the limit switch dials (motor on top) — mounting upside down voids the warranty. Applying 110VAC or 220VAC directly to the motor causes immediate, permanent damage and voids the warranty.
